Equip you with a simple credit card or phone to make the padding.
Clean the surface on which you are going to put your sticker
The first step is to clean the surface or the piece of furniture intended to receive your sticker. In fact, the fat and the dust may prevent a good adhesion.
Make sure the maximum amount that the holder is smooth, because the more the surface is irregular more the pose is complicated.
Then take your landmarks using either of the scotch color or a pencil, to the ask right.
it is important to know that during the installation you will be too close to the surface to have the necessary perspective to an installation well-balanced.
Position your sticker
Start by removing the protective paper your sticker, after you make sure the sticker is well adhered to the transfer.
Position carefully the sticker on its final location and paste the entire surface of the sticker (including the angles), It must not be forgotten that, although often sold as a repositionable, the stickers are, in fact, very difficult to reinstall once glued.
Marouflez from the center to the top and then from the center to the bottom, in order to avoid the formation of air bubbles.
Remove the film transparent of your sticker, and then switch back to a stroke of the squeegee to ensure that there won't be any blisters of air. If despite all your efforts, nasty little bubbles have appeared, don't panic : it is still possible at this stage to take off very gently the sticker from an angle and the reposition smoothing as well with the squeegee to address this unsightly problem.
Polish gently your sticker with a soft cloth to reveal the brilliance of your work.
video source: Leroy Merlin